TreadClimber Belt Lubrication Demonstration Video

This is how to lubricate your TreadClimber using the Lube-N-Walk kit. First of all, you're going to want to take out the magic wand. Then go ahead and apply just a light coating of the silicon-based spray to the magic wand. Just up and down. Then you're just gonna want to go ahead make sure to power down and unplug your machine. After that we can just go ahead and fit the magic wand in at the very bottom of the machine. And you're just going to want to go ahead one full stroke up the length of the treadle. One full stroke back down.

Then we're going to go over how to apply your silicon based lubricant and spray to the other side of the treadle. Again, with your machine unplugged, you're just gonna want to go ahead, lift up the belt, and spray it. Just a thin spray, both up and down the length of the treadle. After we've done that, just go ahead and plug the machine back in. Power it on. Then you're going to want to go ahead and press the power, start, and go ahead and let it run on slow speed for 15 seconds. And after you let the machine run for 15 seconds, you just want to go ahead stop the machine. And if there's any excess lubricant on the belts, or around the belts, you're just going to want to go ahead wipe that up. Also if you've loosened the belts during that time, you'll just want to go ahead and re-tighten them. And that concludes the lubrication of your TreadClimber.